Cohiba Lanceros

How to Cut and Light a Cigar Properly: A Step-by-Step Guide

A great cigar can be ruined in the first minute by a bad cut or a rushed light. The good news is that both are simple to get right. This guide covers the main types of cut, how to light a cigar evenly, and the common mistakes to avoid.

Anatomy of a cigar, in 30 seconds

  • Cap: the small piece of wrapper glued over the closed end (the head). This is what you cut.
  • Head: the closed end you put in your mouth.
  • Foot: the open end you light.
  • Wrapper, binder and filler: the outer leaf, the leaf that holds the bunch together, and the tobacco inside.

How to cut a cigar

Straight cut (guillotine)

The most common cut, suitable for almost every cigar. Using a sharp single- or double-blade cutter:

  1. Find the “shoulder”, where the rounded cap meets the straight body of the cigar.
  2. Cut just above it, typically about 2 mm. You want to open the cap without cutting past it, or the wrapper may unravel.
  3. Cut in one quick, decisive motion. Hesitating crushes the head.

V-cut

A wedge-shaped notch across the cap. It gives a concentrated draw and suits robustos and larger ring gauges. Don’t use it on very thin cigars.

Punch cut

A small circular hole in the cap. It’s neat and the cap stays intact, which works well for wide cigars such as the Behike 56. It’s not suitable for pointed figurados like the Pirámides Extra.

Figurados and pointed heads

For torpedoes and pirámides, use a straight cut a few millimetres down the point. Start small; you can always cut a little more.

How to light a cigar

The aim is an even, gentle light that doesn’t scorch the tobacco.

  1. Choose the right flame. A butane torch or soft-flame lighter, wooden cigar matches, or a cedar spill. Avoid petrol (Zippo-style) lighters and paper matches, which can add off-flavours.
  2. Toast the foot. Hold the cigar at a 45° angle just above the tip of the flame, without touching it, and rotate until the whole foot glows evenly.
  3. Draw gently while rotating. Put the cigar in your mouth, hold the flame just below the foot, and take slow puffs while turning it.
  4. Check the burn. Look at the foot. If one side isn’t lit, touch it up gently.
  5. Blow out once. A gentle exhale through the cigar clears any stale smoke from lighting.

Keeping it lit and burning evenly

  • Take a puff every 30 to 60 seconds. Puffing too fast makes the smoke hot and bitter.
  • If one side burns ahead (“canoeing”), turn the cigar so the slow side faces down, or touch it up with your lighter.
  • Let the ash build: a firm ash helps the cigar burn cooler. Tap it off gently when it’s about 2–3 cm long.
  • If it goes out, blow through it gently to clear stale smoke, then re-toast and relight. It’s fine to relight a cigar within an hour or so.

Common mistakes

  • Cutting too deep: the wrapper unravels. Cut just the cap.
  • A dull cutter: it crushes the head. Replace or sharpen it.
  • Putting the flame directly on the foot: this chars the tobacco and adds bitterness.
  • Smoking dry cigars: they burn hot and fast. Keep cigars at 65–70% humidity; see our storage guide.
  • Inhaling: cigar smoke is for tasting in the mouth, not inhaling.

Smoking outdoors in a Canadian winter

Cold and wind make cigars burn unevenly. Use a torch lighter, choose a shorter size such as a Siglo I or Medio Siglo, and smoke in a sheltered spot. Check your local bylaws first; our guide to cigar rules in Canada covers where you can smoke.

Frequently asked questions

How much of a cigar should I cut?

About 2 mm, just above the shoulder where the cap meets the body.

Can I use a regular lighter?

A butane lighter is fine. Avoid petrol lighters, which can taint the flavour.

Is it OK to relight a cigar?

Yes. Clear the stale smoke, re-toast the foot and relight. It’s best done within an hour or two.

Tobacco products are sold only to adults of legal smoking age in their province or territory. Smoking is harmful to your health.

Leave a Comment

Your email address will not be published. Required fields are marked *